Navigation 

Turbidity (Discharge Monitoring)

Monitoring Turbidity or Suspended Solids in Effluent Discharges.

Monitoring Final Effluent Suspended Solids or Turbidity is a key parameter for assessing the quality of the effluent in respect of meeting discharge consent and permitting levels. It is also an excellent indicator of the basic performance of the treatment works. An increase in the level of Turbidity is an indicator to plant operators that sludge blanket breakthrough is occurring, either through a failure in the treatment process or excessive flow producing poor settlement.

The monitoring is also of major significance in applications where the measurement is taken prior to treatment or discharge to sewer as any rise in the level of turbidity will warn of a process problem upstream of the effluent point. This will allow the operator to avoid causing problems in the effluent treatment plant receiving the flow. This can reduce treatment charges and avoid fines and bad publicity.

Recent changes in Environment Agency policy, covering OMA and OPRA assessments for ERP sites and the increased attention that this giving smaller sites mean that good quality monitoring is essential.

The TurbiTechw² LS Sensor is the product of over 50 years experience of making applications in wastewater and industrial effluent measurements. The sensor employs infrared light at 860 nm using the 90º light scatter principle in accordance with ISO 7027. The user can configure the sensor and it’s accompanying 7300w² Monitor to measure either suspended solids or turbidity, depending on the requirements of the application. The TurbiTechw² LS sensor incorporates a self cleaning mechanism that has repeatedly been proven to be market leading.

The terms Suspended Solids and Turbidity are widely used and interchanged without full consideration for the actual measurement being taken. The vast majority of the instruments available for these applications use an infrared light source that emits light into the sample with a detector placed at 90º to the light source. This internationally recognised principle of operation produces a linear response to increasing levels of Turbidity.

When setting the instrument up, the user needs to consider the correct units of measurement, the calibration method to be used, and how the data will be reported. If the measurement is being made for regulatory reasons the 7300w² Monitor should be set up to use the same units as the regulator is using. For EPR sites this is likely to be FTU, and therefore the instrument should be set up to measure turbidity. The calibration standard would then be Formazin. Most standard discharge consents use mg/l which implies that suspended solids measurement is required and calibration will be carried out using reference to a laboratory solids analysis.

Calibration of the system in suspended solids units is based on the assumption that the solids present in the sample analysed by the laboratory are representative of the normal process conditions and that the distribution of particle size, density and colour do not change between calibrations. This is a reasonable assumption when monitoring solids at the outlet of a treatment plant where the effluent is thoroughly mixed by the process, becoming fairly homogeneous.

Using turbidity as the measurement provides a straight forward calibration process, that is easy to reproduce and make traceable, for trend monitoring this is the preferred option. Care needs to be taken interpreting the information from the system when relating the Turbidity value to suspended solids discharge parameters.

For specialist advice call:

+44 (0)1726 879800

Online Enquiry

7300w2 Monitor

7300w² Monitor

The core product in the WaterWatch² range - the 7300w² Monitor provides all the user interface and system configuration

More Details
TurbiTechw² Optics

TurbiTechw² LS Suspended Solids and Turbidity Sensor

Self Cleaning Suspended Solids or Turbidity sensor designed for discharge and inlet monitoring

More Details

Effluent Discharge

Monitoring at the effluent discharge point is the last chance to prevent pollution incidents and allows comparison with regulatory authority sampling

More Details

To speak with one of our specialist advisors, call

+44 (0)1726 879800


or complete our

Online Enquiry
Enquiry

Your Name (required)

Your Email (required)

Subject

Your Message

×
Enquiry

Your Name (required)

Your Email (required)

Subject

Your Message

×